← all systems · see it in The System
Fold (geology)
'In structural geology, a fold is a stack of originally planar surfaces, such as sedimentary strata, that are bent or curved ("folded") during permanent deformation.'
Properties published scienceour proposal
Sourced fields, and our own readings.
| born at | not given in the sources read; the oldest named deformation is the Eoarchaean deformation at Isua (amphibolite facies reached about 3.7-3.6 Ga), where folds are not named |
| boundary | Inside: the bent layers (hinge, limbs, axial surface), the mechanisms that keep their volume while they shorten (slip, buckling, dissolution, flow), and what the fold gathers (veins, trapped fluids). Outside: the stress source (plates, faults, intrusions), the crust it sits in, the pore water, gravity, heat, and the rivers that erode it. |
| nested level | Built from strata (sediment, metamorphic or igneous layering) and their mineral grains; embedded in the crust, in orogens and fold-and-thrust belts; driven by plate convergence; at lithospheric scale a fold of the plate itself. |
| scale | planetary |
Measures (20) published science
| fold size range | microscopic crinkles to mountain-sized folds; folding up to the size of lithospheric plates |
| dominant wavelength (Biot, viscous single layer) | Ld = 2 pi H (R/6)^(1/3): proportional to thickness H, rising with viscosity ratio R (first derived by Biot 1957) length |
| interlimb angle classes | gentle 180-120, open 120-70, close 70-30, tight 30-0; isoclinal 10-0 degrees |
| viscosity ratio for wavelength lock-in | large ratios (about 50 or more) |
| limb dip where exponential growth breaks down | about 24 degrees at viscosity ratio 25; about 15 degrees at 100 |
| effective viscosity ratio sufficient for folding (power-law, n = nm = 3) | about 8 or more ratio |
| initial amplitude threshold for explosive folding (alpha = 20) | 0.026 H (H = layer thickness) length |
| lithospheric fold wavelength, northern Indian Ocean | 130-250 km observed (McAdoo and Sandwell 1985); about 137 km dominant wavelength for the model values |
| force per unit length from Tibetan plateau potential energy | about 7 x 10^12 (Molnar and Lyon-Caen 1988; said by thin-sheet models to be overestimated by a factor of 2) N/m |
| stress to fold oceanic lithosphere | elastic theory: 4 GPa or more (unrealistic); elasto-plastic (McAdoo and Sandwell 1985): about 600 MPa |
| tectonic strain rates | 10^-12 to 10^-15 (laboratory 10^-4 to 10^-6) 1/s |
| share of world petroleum found in anticlinal traps | about 80 % |
| Zagros share of fold-and-thrust-belt hydrocarbon reserves | about 49% of FTB reserves; about 7% of all reserves; belt about 1,800 km long |
| Ventura anticline uplift rate (characteristic clock) | 5 (basin converging 7-10 mm/yr) |
| river anticline formation time (characteristic clock) | up to ten thousand years yr |
| river anticline uplift zone width | 50-80 km |
| erosion rate, Himalaya average vs Arun River | about 1 vs up to 8 mm/yr |
| boudin size range | about 1 cm to about 20 m thick |
| exhumation rate along river anticlines | sustained up to 5 (tectonic aneurysms up to 10) mm/yr |
| first scientific observations of folds; first folding experiment | 1705 (Marsili and Scheuchzer, Lake Uri); 1815 (Hall, cloth layers under a loaded door) year |
Open contentions (3) open contention
Where sources or readings disagree. Both stay on the map.
- C-254 What is buckling the sea bed south of India?
booked: The map follows the view that the India-Asia collision is folding it, possibly pushed by Tibet's weight, and keeps the models showing Tibet alone is not enough alongside.
the other reading: thin viscous sheet models put that force about 2 times too high, so Tibet alone could not be responsible (Ghosh et al. 2006, 2009) - C-255 Are tectonic plates rigid, or can they fold?
booked: The map follows the evidence that plates can fold and stretch, and keeps the rigid-plate picture alongside.
the other reading: the rigid-plate paradigm of plate tectonics - C-256 Is Alaska's Saint Elias range a 'tectonic aneurysm'?
booked: The map lists the confirmed cases elsewhere and keeps Saint Elias as a proposal, with the alternative explanation alongside.
the other reading: Saint Elias: insufficient focused exhumation; transpressional faulting explains the young ages
Partners and parts published science
Built from / builds (3)
Sits inside / holds (4)
- Planet
- Earth's crust (primordial, oceanic and continental)
- Fold and thrust belt
- Orogens (orogenic zones)
Trades with (valence) (11)
- Water cycle (hydrologic cycle) via sys:water-cycle · Fold (geology) mixed
- Gravitational field via sys:gravitational-field · Fold (geology) mixed
- Earth's crust (primordial, oceanic and continental) via sys:gravitational-field · Fold (geology) gain
- Mantle convection (with plate tectonics, its surface expression) via sys:mechanical-contact · Fold (geology) gain
- Aqueous solution via sys:aqueous-solution · Fold (geology) mixed
- Seafloor sediment (marine sediment) via sys:gravitational-field · Fold (geology) gain
- Thermal energy (heat, temperature and heat flow) via sys:thermal-energy · Fold (geology) mixed
- Mineral via sys:aqueous-solution · Fold (geology) gain
- Thrust faults (fault-bend, fault-propagation and detachment folds) via sys:mechanical-contact · Fold (geology) gain
- Petroleum (oil and gas trapped in anticlines) via sys:gravitational-field · Fold (geology) even
- High-level igneous intrusion (laccolith) via sys:mechanical-contact · Fold (geology) gain
expressed by (1)
floor filled by (21)
- Water cycle (hydrologic cycle)
- Gravitational field
- Earth's crust (primordial, oceanic and continental)
- Mantle convection (with plate tectonics, its surface expression)
- Aqueous solution
- Seafloor sediment (marine sediment)
- Thermal energy (heat, temperature and heat flow)
- Mineral
- River
- Strata (layers of rock or sediment)
- Axial-planar cleavage (fabric in the fold)
- Syncline
- Anticline
- Dome
- Salt dome
- Fold and thrust belt
- Orogens (orogenic zones)
- Thrust faults (fault-bend, fault-propagation and detachment folds)
- Petroleum (oil and gas trapped in anticlines)
- High-level igneous intrusion (laccolith)
- migmatite
represents (1)
Kinds (24)
- Syncline
- Anticline
- Antiform
- Synform
- Recumbent fold
- Monocline
- Basin (structural)
- Dome
- Chevron fold
- Slump fold
- Ptygmatic fold
- Parasitic fold
- Disharmonic fold
- Sheath fold
- Box fold
- Kink band
- Buckle (flexure) fold
- Fault-bend fold
- Fault-propagation (tip-line) fold
- Detachment fold
- Flow (passive) fold
- River anticline
- Rollover anticline
- Ramp anticline
Notes published science
- Folding and necking are one instability with the sign flipped: squeeze a stiff layer and it buckles into a wave whose wavelength can lock in; stretch it and it thins into pinch-and-swell that can't lock in. Necking needs a much narrower range of conditions, which is why folds are everywhere and pinch-and-swell is rare (Schmalholz & Mancktelow 2016).
- Rivers can raise mountains: where a big river cuts fast through weak crust, the unloaded crust bounces up along it into a fold, which brings more weak rock up to be cut. The Arun erodes up to 8 mm a year against a Himalayan average of 1, and exhumation along these rivers runs up to 5 mm a year (src:wp:river-anticlines).
- Lithospheric folding was once 'considered impossible' on elastic theory (4 GPa or more needed). Then the floor of the northern Indian Ocean turned out to be folded into 130-250 km waves by the India-Asia collision, at about 600 MPa once the lithosphere was treated as elasto-plastic (SM2016).
Layers
The ways it takes in its world, where they meet, and how it acts back, each from L1 (where it meets the world) up.
erosion of folds (breached anticlines, anticlinal valleys and river anticlines)
- L1: Uplifted crest exposed to rain and rivers.
- L2: The core erodes deeper than the flanks: oldest beds exposed at an anticline's core; eroded domes show a bullseye, oldest inward; competent rock weathers slower.
- L3: Incision: breached or scalped anticlines cut by streams into anticlinal valleys; large rivers remove rock fast (Arun up to 8 mm/yr).
- L4: Unloading: removal along the river lets the crust rebound (gravity floor 3), focusing uplift and exhumation (up to 5 mm/yr; aneurysms up to 10).
gravity: overburden, buoyancy and rebound in folded rock
- L1: Weight against deflection: the load term q = rho g A (Smoluchowski 1909), mathematically the same as an elastic foundation's resistance.
- L2: The Argand number for folding, gravitational over compressive stress, sets the dominant wavelength of a layer floating on a weak medium (lithospheric folds).
- L3: Isostatic rebound: where big rivers unload weak crust, it rises along the river and bends into a river anticline (50-80 km wide; up to ten thousand years); with very weak crust, a tectonic aneurysm.
- L4: Buoyancy in the fold: oil and gas migrate up into the crest and fill it to the spill point under an impermeable seal; rock salt pushes up into overlying rock (salt domes).
heat and depth (temperature sets how the rock folds)
- L1: Temperature and depth: folds form under varied temperature gradients, from soft sediments through the full spectrum of metamorphic rocks.
- L2: Hot, deep rock behaves as a fluid: passive-flow folds at high temperature with no mechanical contrast; ptygmatic folds in migmatites.
mechanical load: layer-parallel shortening of layered rock (stress, rheology and buckling)
- L1: The load: shortening of existing layers by plate convergence, displacement on non-planar faults, fault tips, differential compaction or a high-level intrusion; 'Folds in the rock are formed about the stress field in which the rocks are located'.
- L2: The layering read by its rheology: 'The response depends on the thickness of the mechanical layering and the contrast in properties between the layers'; competence (resistance to deformation or flow); the viscosity ratio R of layer to matrix.
- L3: The instability: the flat layer is unstable under shortening; deflections grow exponentially at a constant rate (first order); the dominant wavelength Ld = 2 pi H (R/6)^(1/3) grows fastest and is selected and 'locked in' at large R; below a critical contrast no selection; small starting bumps thicken first, then 'explosive' folding.
- L4: Accommodation, keeping volume: flexural slip between beds, buckling with layer-parallel shortening and thickening, mass displacement by pressure dissolution, or passive flow where the rock behaves as a fluid.
- L5: The finite fold: hinge, limbs, axial surface; anticline (oldest at core) and syncline (youngest), dome and basin; gentle to isoclinal; concentric (active buckling) or similar (shear flow); effective viscosity lowered by the fold's own geometry (structural softening).
- L6: Trains, belts and scales: fold trains and parasitic folds, fold belts in orogenic zones, fold-and-thrust belts propagating into the foreland (new thrusts fold the old), lithospheric folds of 130-250 km in the northern Indian Ocean.
pore water in folding rock (pore pressure, pressure solution and veins)
- L1: Pore fluid and pore pressure in the layers: folds form under varied pore pressure.
- L2: Pressure solution: dissolution at grain-to-grain contacts under high stress, redeposition at low stress or removal in the fluid.
- L3: Hinge voids: large deformation in the hinge opens voids with lower water pressure that trigger mineral deposition; veins, saddle reefs (gold at Hill End; quartz at The Ovens).
- L4: Axial-planar cleavage: solution transfer and grain rotation align a planar fabric that records the attitude of the major fold's axial plane.
Sources (15) published science
River anticlines (behind its links)
Anticline (behind its links)
Fold and thrust belt (behind its links)
Pressure solution (behind its links)
Cleavage (geology) (behind its links)
Wrinkle ridge (behind its links)
Structural trap (behind its links)
Zagros fold and thrust belt (behind its links)
Boudinage (behind its links)
Orogeny (behind its links)
Syncline (behind its links)
Monocline (behind its links)
Detachment fold (behind its links)